Reducing latency

Latency is the delay between moving a stick and seeing the helicopter respond. Much of it comes from outside HeliSense — the network between a WiFi radio and your device, and how your Mac is showing the picture — and that part you can do something about.

WiFi radios: start with the network

If you fly with a VBar Control or an ExpressLRS transmitter over WiFi, the network between the radio and your device is the most likely source of delay. Both radios use 2.4 GHz WiFi, which on most home networks is the busier band, shared with the neighbours’ networks as well as your own. There is no setting on the radio to change that, so the way to improve it is the network around the radio.

  • Keep the radio close to the router. The same goes for your iPhone, iPad or Mac if it is on WiFi. Distance and walls weaken the signal, and a weak signal is a slower one.
  • Use a quiet network. The less else is going on — streaming, downloads, video calls — the clearer the run for the stick data. If you can set up a separate network just for flying, with little or nothing else on it, better still.
  • Use the radio’s own access point, where it has one. ExpressLRS can advertise a network of its own, so your device connects straight to the transmitter with no router in between. See setting the transmitter’s network.
  • Try your phone’s hotspot. Connect the radio to the hotspot, and the device running HeliSense too if it is not the phone itself. It is a small network with nothing else on it.
Your device and the radio may consume mobile data while they are on the hotspot. The stick data itself travels between them locally and does not.

On Mac: fly in full screen

In a window, macOS has to composite HeliSense’s picture with the rest of the desktop before it reaches the screen. In full screen that step drops out. Measured in the Simulator, flying in a window costs one or two refreshes of the display: 8–17 ms on a 120 Hz display, such as a MacBook Pro’s, and 17–33 ms on a 60 Hz one.

To go full screen, click the green button at the top left of the HeliSense window, or press Control-Command-F.

Full screen also switches on macOS Game Mode. It gives HeliSense first call on the processor and graphics, and doubles the rate at which macOS reads Bluetooth controllers — worth having if you fly with an Xbox, PlayStation or MFi controller.

On macOS Golden Gate 27, Game Mode can make menus slow to open in full screen. If you see that, see slow menus in full screen for how to turn it off.

On Mac with an external display: fly on the main display

With more than one display connected, latency is lowest on the one macOS is using as the main display. If you fly on an external display, make that one the main display:

  1. Open System Settings and choose Displays.
  2. Select the display you fly on.
  3. Set Use as to Main display.

Then move the HeliSense window onto that display and go full screen there. On a MacBook Pro this matters for smoothness as well: full screen on the built-in display can stutter while an external monitor is the main display. See stuttering on the built-in display.

Still feels delayed?

Tell us what you fly with, on which device, and how it is connected, through the contact page, and we’ll look into it.